Remote Node Filter - Nortel BCM50a Configuration Manual

Table 13 Menu 11.3 Remote Node Network Layer Options (continued)
Field
Multicast
After you complete this menu, press [ENTER] at the prompt "Press ENTER to Confirm..."
to save your configuration, or press [ESC] at any time to cancel.

Remote Node filter

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press
[SPACE BAR] to set the value to Yes. Press [ENTER] to open
Remote Node Filter.
Use menu 11.1.4 to specify the filter sets to apply to the incoming and outgoing
traffic between this remote node and the BCM50a Integrated Router to prevent
certain packets from triggering calls. You can specify up to 4 filter sets separated
by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are
accepted in this field. For more information on defining the filters, please refer to
Chapter 11, "Filter
the additional option of specifying remote node call filter sets.
Description
IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to
version 2 and None disables IGMP.
configuration. For PPPoE or PPPoA encapsulation, you have
BCM50a Integrated Router Configuration — Advanced
Chapter 6 Remote Node setup 77
Menu 11.1.4-
Example
None