Ip Alias Setup; Table 9 Lan Tcp/Ip Setup Menu Fields - Nortel BCM50a Configuration Manual

Use the instructions in

Table 9 LAN TCP/IP setup menu fields

Field
TCP/IP Setup:
IP Address
IP Subnet Mask
RIP Direction
Version
Multicast
Edit IP Alias

IP Alias Setup

You must use menu 3.2 to configure the first network. Move the cursor to the Edit
IP Alias field, press [SPACE BAR] to choose Yes and press [ENTER] to
configure the second and third network.
Press [ENTER] to open Menu 3.2.1 - IP Alias Setup, as shown in
Table 9 to configure TCP/IP parameters for the LAN port.
Description
Enter the IP address of your BCM50a Integrated
Router in dotted decimal notation.
Your BCM50a Integrated Router automatically
calculates the subnet mask based on the IP
address that you assign. Unless you are
implementing subnetting, use the subnet mask
computed by the BCM50a Integrated Router.
Press [SPACE BAR] and then [ENTER] to select
the RIP direction. Options are: Both, In Only,
Out Only or None.
Press [SPACE BAR] and then [ENTER] to select
the RIP version. Options are:
RIP-1, RIP-2B or RIP-2M.
IGMP (Internet Group Multicast Protocol) is a
network-layer protocol used to establish
membership in a Multicast group. The BCM50a
Integrated Router supports both IGMP version 1
(IGMP-v1) and version 2 (IGMP-v2). Press
[SPACE BAR] and then [ENTER] to enable IP
Multicasting or select None (default) to disable it.
The BCM50a Integrated Router supports three
logical LAN interfaces via its single physical
Ethernet interface with the BCM50a Integrated
Router itself as the gateway for each LAN
network. Press [SPACE BAR] to select Yes and
then press [ENTER] to display menu 3.2.1.
BCM50a Integrated Router Configuration — Advanced
Chapter 4 LAN setup 61
Example
192.168.1.1
(default)
255.255.255.0
Both
(default)
RIP-1
(default)
None
Yes
Figure 15.