Configuring A Server Behind Nat - Nortel BCM50a Configuration Manual

Table 20 Menu 15.1.1.1: Editing or configuring an individual rule in a set
Field
Global IP
Start
End

Configuring a server behind NAT

Note: If you do not assign a Default Server IP address, the BCM50a Integrated Router
discards all packets received for ports that are not specified here or in the remote
management setup.
Follow these steps to configure a server behind NAT:
1
2
Description
Enter the starting global IP address (IGA). If you have a
dynamic IP, enter 0.0.0.0 as the Global IP Start. Note that
Global IP Start can be set to 0.0.0.0 only if the types are
Many-to-One or Server.
Enter the ending global IP address (IGA). This field is N/A for
One-to-One, Many-to-One and Server types.
After you finish configuring a rule in this menu, press [ENTER]
at the message "Press ENTER to Confirm..." to save your
configuration, or press [ESC] to cancel.
Enter 15 in the main menu to go to Menu 15 - NAT Setup.
Enter 2 to go to Menu 15.2 - NAT Server Setup.
Chapter 9 Network Address Translation (NAT) 99
BCM50a Integrated Router Configuration — Advanced
Example
0.0.0.0
N/A