Figure 39 Menu 15.2 - Nat Server Setup - Nortel BCM50a Configuration Manual

102 Chapter 9 Network Address Translation (NAT)
5
6
Figure 39 Menu 15.2 – NAT Server Setup
Rule
------------------------------------------------------
001
002
003
004
005
006
007
008
009
010
Select Command= None
Press ENTER to Confirm or ESC to Cancel:
You assign the private network IP addresses. The NAT network appears as a
single host on the Internet. A is the FTP/Telnet/SMTP server.
N0115791
Enter the inside IP address of the server in the IP Address field. In the
following figure, you have a computer acting as an FTP, Telnet and SMTP
server (ports 21, 23 and 25) at 192.168.1.33.
Press [ENTER] at the "Press ENTER to confirm ..." prompt to save your
configuration after you define all the servers or press [ESC] at any time to
cancel.
Menu 15.2 - NAT Server Setup
Default Server: 0.0.0.0
Act. Start Port
No 0
Yes 21
No 0
No 0
No 0
No 0
No 0
No 0
No 0
No 0
End Port IP Address
0 0.0.0.0
25 192.168.1.33
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
Select Rule= N/A