Ip Commands; Table 59 Ip Commands - Nortel BCM50a Configuration Manual

250 Appendix G Command Interpreter
Table 58 Ether Commands
Command
status
version
edit
load
mtu
accessblock
speed
save
dynamic
Port
dump
set
spt

IP commands

Table 59
preceded by

Table 59 IP commands

Command
address
alias
aliasdis
arp
N0115791
disp <name>
<ch_name>
<1:LAN>
<value>
<0:disable 1:enable>
<auto|10/half|10/
full|100/half|100/
full>
<port> <type>
lists and describes the IP commands. Each of these commands must be
. For example, type
ip
[addr]
<iface>
<0|1>
Description
Displays the Ethernet driver counters.
Shows the LAN status.
Displays the Ethernet device type.
Loads Ethernet (1:LAN) data from the System
Parameters Table.
Sets the Ethernet data Maximum Transmission
Unit.
Blocks Internet access.
Sets the Ethernet data speed and duplex.
Saves Ethernet data to the System Parameters
Table.
Displays the relationship between physical port
and channel.
Sets physical port to a specific channel.
Displays channel setting stored in SPT.
to display the host IP address.
ip address
Description
Displays the host IP address.
Sets an alias for the specified interface.
Disables or enables the alias for the specified
interface.