Figure 57 Menu 21.1.1.1 - Tcp/Ip Filter Rule; Table 25 Tcp/Ip Filter Rule Menu Fields - Nortel BCM50a Configuration Manual

124 Chapter 11 Filter configuration
Figure 57 Menu 21.1.1.1 – TCP/IP Filter Rule
Menu 21.1.1.1 - TCP/IP Filter Rule
Press Space Bar to Toggle.
Table 25

Table 25 TCP/IP Filter Rule Menu fields

Field
Active
IP Protocol
IP Source Route
Destination
IP Address
N0115791
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 0
Destination: IP Addr=
IP Mask=
Port #=
Port # Comp= None
Source: IP Addr=
IP Mask=
Port #=
Port # Comp= None
TCP Estab= N/A
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
describes how to configure your TCP/IP filter rule.
Description
Press [SPACE BAR] and then [ENTER] to select
Yes to activate the filter rule or No to deactivate it.
Protocol refers to the upper layer protocol, for
example, TCP is 6, UDP is 17 and ICMP is 1. Type a
value between 0 and 255. A value of 0 matches ANY
protocol.
Press [SPACE BAR] and then [ENTER] to select
Yes to apply the rule to packets with an IP source
route option. Otherwise the packets must not have a
source route option. The majority of IP packets do
not have source route.
Enter the destination IP Address of the packet you
wish to filter. This field is ignored if it is 0.0.0.0.
IP Source Route= No
Log= None
Options
Yes
No
0-255
Yes
No
0.0.0.0