Edit Ip/Bridge - Nortel BCM50a Configuration Manual

74 Chapter 6 Remote Node setup
Table 12 Menu 11.1 Remote Node Profile (continued)
Field
Edit ATM
Options
Edit Advance
Options
Telco Option
Allocated
Budget (min)
Period (hr)
Schedule Sets This field is only applicable for PPPoE and PPPoA
Nailed up
Connection
Session
Options
Edit Filter
Sets
Idle Timeout
(sec)
After you complete this menu, press [ENTER] at the prompt "Press ENTER to Confirm..."
to save your configuration, or press [ESC] at any time to cancel.

Edit IP/Bridge

1
N0115791
Description
Press [SPACE BAR] to select Yes and press [ENTER] to
display Menu 11.6 – Remote Node ATM Layer Options.
This field is only available when you select PPPoE in the
Encapsulation field.
Press [SPACE BAR] to select Yes and press [ENTER] to
display Menu 11.8 – Advance Setup Options. This field is
not available on all models.
This sets a ceiling for outgoing call time for this remote
node. The default for this field is 0 meaning no budget
control.
This field is the time period that the budget should be reset.
For example, if we are allowed to call this remote node for a
maximum of 10 minutes every hour, then the Allocated
Budget is (10 minutes) and the Period (hr) is 1 (hour).
encapsulation. You can apply up to four schedule sets here.
For more details please refer to the
This field is only applicable for PPPoE and PPPoA
encapsulation. This field specifies if you want to make the
connection to this remote node a nailed-up connection.
More details are given earlier in this section.
Use [SPACE BAR] to choose Yes and press [ENTER] to
open menu 11.5 to edit the filter sets. See the
filter section for more details.
Type the number of seconds (0-9999) that can elapse when
the BCM50a Integrated Router is idle (there is no traffic
going to the remote node), before the BCM50a Integrated
Router automatically disconnects the remote node. 0 means
that the session will not timeout.
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 –
Remote Node Network Layer Options as shown next.
Call scheduling chapter.
Remote Node
Example
No
No
No
(default)