Figure 31 Menu 11.3 - Applying Nat To The Remote Node; Table 17 Applying Nat In Menus 4 & 11.3 - Nortel BCM50a Configuration Manual

Figure 31 Menu 11.3 – Applying NAT to the Remote Node
Menu 11.3 - Remote Node Network Layer Options
IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 15
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
Press Space Bar to Toggle.
Table 17
Table 17 Applying NAT in Menus 4 & 11.3
Field
Network
Address
Translation
Enter here to CONFIRM or ESC to CANCEL:
describes the fields in
Description
When you select this option the SMT uses Address
Mapping Set 1 (menu 15.1 -
page 92 for further discussion). Choose Full Feature if you
have multiple public WAN IP addresses for your BCM50a
Integrated Router.
When you select Full Feature you must configure at least
one address mapping set!
NAT is disabled when you select this option.
When you select this option the SMT uses Address
Mapping Set 255 (menu 15.1 -
page 92). Choose SUA Only if you have just one public
WAN IP address for your BCM50a Integrated Router.
BCM50a Integrated Router Configuration — Advanced
Chapter 9 Network Address Translation (NAT) 91
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Figure 31.
"Address Mapping Sets" on
"Address Mapping Sets" on
Options
Full Feature
None
SUA Only