Nortel BCM50a Configuration Manual page 244

244 Appendix G Command Interpreter
Table 56 Sys commands
Command
load
mail
save
syslog
N0115791
disp
online
alertAddr [mail address]
clearLog [0:no/1:yes]
display
logAddr [mail address]
schedule display
schedule hour [0-23]
schedule minute [0-59]
schedule policy [0:full/
1:hourly/2:daily/3:weekly/
4:none]
schedule week [0:sun/1:mon/
2:tue/3:wed/4:thu/5:fri/
6:sat]
server [domainName/IP]
subject [mail subject]
auth
user
passwd
active [0:no/1:yes]
Description
Displays the error log.
Turns the error log online display on or
off.
Loads the log settings buffer. Use this
command before you configure the log
settings. Use sys logs save after
you configure the log settings.
Sends alerts to this e-mail address.
Enables the switch to clear the log after
sending logs via e-mail.
Displays the logs and alerts mail
settings.
Sends logs to this e-mail address.
Displays the mail schedule.
Sets the hour to send logs.
Sets the minute to send the logs.
Sets the mail schedule policy.
Sets the day of the week to send
weekly logs.
Sets the domain name or IP address of
the mail server to which the logs are
sent.
Sets the log e-mail's subject.
Enables or disables SMTP
authentication.
Sets the SMTP authentication
username.
Sets the SMTP authentication
password.
Saves the log settings from the buffer.
Enables or disables syslog logging.