Figure 71 Menu 24.1 - System Maintenance - Status; Table 30 Menu 24.1 System Maintenance: Status - Nortel BCM50a Configuration Manual

3
There are three commands in Menu 24.1 - System Maintenance - Status.
Entering 1 drops the WAN connection, 9 resets the counters and [ESC] takes
you back to the previous screen.
Figure 71 Menu 24.1 – System Maintenance – Status
Node-Lnk Status
1-ENET N/A
My WAN IP (from ISP): 0.0.0.0
Ethernet:
Status: 100M/Full Duplex Tx Pkts: 608
Collisions: 0
CPU Load = 1.19%
Table 30
Status. These fields are read-only and meant for diagnostic purposes. The upper
right corner of the screen shows the time and date according to the format you set
in menu 24.10.

Table 30 Menu 24.1 System Maintenance: Status

Field
Node-Lnk
Status
TxPkts
RxPkts
Errors
Tx B/s
Rx B/s
Menu 24.1 - System Maintenance - Status
TxPkts RxPkts
0 0
Rx Pkts: 821
Press Command:
COMMANDS: 1-Reset Counters
describes the fields present in Menu 24.1 - System Maintenance -
Description
This is the node index number and link type. Link types are: PPP, ENET,
1483.
This shows the status of the remote node.
The number of transmitted packets to this remote node.
The number of received packets from this remote node.
The number of error packets on this connection.
This shows the transmission rate in bytes per second.
This shows the receiving rate in bytes per second.
BCM50a Integrated Router Configuration — Advanced
Chapter 14 System information and diagnosis 147
Errors Tx B/s
0 0
WAN:
Line Status: Initializing
Upstream Speed:
Downstream Speed:
ESC-Exit
11:48:18
Tue. Jun. 06, 2006
Rx B/s Up Time
0 0:00:00
0 kbps
0 kbps