Sys Firewall Commands; Table 62 Sys Firewall Commands - Nortel BCM50a Configuration Manual

268 Appendix G Command Interpreter

Sys firewall commands

Table 62
commands must be preceded by
firewall active yes
Table 62 Sys firewall
Command
acl
disp
active <yes|no>
cnt
disp
clear
dynamicrule display
tcprst
rst
rst113
display
dos
smtp
display
ignore
ignore
dos
logBroadcast
triangle
N0115791
lists and describes the system firewall commands. Each of these
to turn on the firewall.
commands
Description
Displays ACLs or a specific ACL set # and rule #.
Activates or deactivates firewall
Enables or disables the firewall.
Displays the firewall log type and count.
Clears the firewall log count.
Displays the firewall's dynamic rules.
Turns TCP reset sending on or off.
Turns TCP reset sending for port 113 on or off.
Displays the TCP reset sending settings.
Enables or disables the SMTP DoS defender.
Displays the SMTP DoS defender setting.
Sets if the firewall ignores DoS attacks on the LAN or WAN.
Sets if the firewall ignores DoS attacks on the LAN or WAN.
Displays the status of the broadcast log.
Sets if the firewall ignores triangle route packets on the LAN or WAN.
. For example, type
sys firewall sys