Basic Setup Complete - Nortel BCM50a Configuration Manual

Table 11 Menu 4 Internet access setup (continued)
Field
Idle Timeout
IP Address
Assignment
IP Address
Network
Address
Translation
Address
Mapping Set
After you complete this menu, press [ENTER] at the prompt "Press ENTER to Confirm..."
to save your configuration, or press [ESC] at any time to cancel.

Basic setup complete

You have successfully connected, installed, and set up your BCM50a Integrated
Router to operate on your network, as well as access the Internet.
If all your settings are correct, your BCM50a Integrated Router can connect
automatically to the Internet. If the connection fails, note the error message that
you receive on the screen and take the appropriate troubleshooting steps.
You can deactivate the firewall in menu 21.2 or using the embedded WebGUI in
the BCM50a Integrated Router. You can also define additional firewall rules or
modify existing ones, but exercise extreme caution in doing so. For more
information about the firewall, see BCM50a Integrated Router Configuration -
Basics (N0115790).
Description
This value specifies the number of idle seconds that
elapse before the BCM50a Integrated Router
automatically disconnects the PPPoE session.
SPACE BAR
Press [
address assignment.
Enter the IP address supplied by your ISP, if
applicable.
SPACE BAR
Press [
Full Feature. For more details about the single user
account (SUA) feature, see
Account) Versus NAT" on page
Type the numbers of mapping sets (1-8) to use with
NAT. See the
Translation (NAT)," on page 89
Note: If the firewall is activated, the default policy can communicate
with the Internet if the communication originates from the LAN, and
blocks all traffic to the LAN that originates from the Internet.
BCM50a Integrated Router Configuration — Advanced
] to select Static or Dynamic
] to select None, SUA Only or
"SUA (Single User
89.
Chapter 9, "Network Address
for details.
Chapter 5 Internet access 67
Example
0
Dynamic
N/A
SUA Only
N/A