Cpu Card; Removal - IBM H Series Installation And Service Manual

CPU Card

Removal

1. Place the drawer in the rear service position, as described in "Rear Service
Position" on page 7-28.
2. Locate the CPU card that needs replaced.
3. For Model H50 only, disconnect the power cable from the top of the CPU card.
4. Lift both camming latch mechanisms at the same time that hold the CPU card in
position.
Attention: Do not use the heat sink as a handle, as this can damage the CPU
card.
7-40
RS/6000 Enterprise Server Model H Series Installation and Service Guide