IBM H Series Installation And Service Manual page 407

done
disconnect:
delay 2
send "+++"
delay 2
send "ATH \r"
ignore " \r" or "OK\r" timeout 2
send "ATE Q1\r"
ignore " \r" timeout 1
done
condin: send "AT&F E E \r"
ignore " \r" or "OK\r\n" timeout 2 # Ignore modem response.
send "AT#F Q2\r"
expect " \r" or "OK\r\n" timeout 2 # Confirm commands successful
send "ATV X S =2\r"
expect " \r" timeout 2
done
waitcall: ignore "2\r" timeout 1
expect "2\r" timeout 1
expect "1\r" timeout 6
done
page: send "ATD%N,%R\r"
expect " \r" or "3\r" timeout 3
delay 2
send "+++"
delay 2
send "ATH \r"
expect " \r" timeout 2
done
ripo: send "AT&F E E \r"
ignore " \r" or "OK\r\n" timeout 2 # Ignore modem response.
send "AT#F Q2\r"
# Separate from previous data.
# Assure command mode.
# Allow mode switching delay.
# Set modem switch-hook down
# (i.e., hang up).
# Ignore modem response.
# Initialize modem: Echo OFF,
# Disable responses.
# Reset to factory defaults.
# E =data compression disabled
# E =echo disabled
# Trellis modulation disabled
# Retrain with adaptive rate
# Numeric response code
# AT compatible messages
# Answer on 2nd ring
# Confirm commands successful.
# Ignore first ring.
# Pick up second ring
# or timeout.
# Expect a connection response.
# %N = pager call center number
# commas=6sec wait time to
# enter paging number.
# %R = return number
# Confirm successful command.
# Wait before hanging up.
# Assure command mode.
# Allow mode switching delay.
# Hang up.
# Confirm successful command.
# Reset to factory defaults.
# E =data compression disabled
# E =echo disabled
# Trellis modulation disabled
# Retrain with adaptive rate
Appendix E. Modem Configurations
E-13