Chapter 3. Error Code To Fru Index - IBM H Series Installation And Service Manual

Table 3-8 (Page 4 of 10). Firmware Checkpoints.
Checkpoint Description
E155 Probe PCI bridge secondary bus
E156 Create PCI Ethernet node
E15A Create 64 bit host (primary) PCI
controller node
E15B Transferring control to Operating
System (service mode boot)
E15C Probe primary 64 bit PCI bus
E15D Create host PCI controller node
E15E Create MPIC node
E15F Adapter VPD probe
E160 CPU node VPD creation
E161 Root node VPD creation
E162 service processor node VPD cre-
ation
E164 Create PCI graphics node (P9)
E168 Create PCI graphics node (S3)
E16C GTX100P Subsystem Open request.
E16D GTX100P Planar not detected or
failed diagnostics.
E16E GTX100P Subsystem Open suc-
cessful.
E16F GTX100P Close Subsystem.
E170 Start of PCI Bus Probe
E171 Executing PCI-Delay function
E174 Establish host connection
E175 BootP request
Action/
Possible Failing FRU
Go to "Step 1540-25" on page 2-61.
If a network adapter or I\O board is
replaced, see 3-1.
See the note on 3-45.
See the note on 3-45.
See "Boot Problems and Concerns"
on page 3-65.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
Refer to "Boot Problems and
Concerns" on page 3-65 for general
considerations.
Refer to "Boot Problems and
Concerns" on page 3-65 for general
considerations.
1. Turn off then on, and retry the
boot operation.
2. Verify the network connection
(network could be down).
3. Have network administrator
verify the server configuration
for this client.

Chapter 3. Error Code to FRU Index

3-55