IBM H Series Installation And Service Manual page 111

Table 3-1 (Page 2 of 40). Firmware Error Codes.
Error Code Description
20E00000 Power on Password entry error
20E00001 Privileged-access password entry
error
20E00002 Privileged-access password jumper
not enabled
20E00003 Power on Password must be set for
Unattended mode
20E00004 Battery drained or needs replace-
ment
20E00005 EEPROM locked
20E00008 CMOS corrupted or tampering
evident, CMOS initialized
20E00009 Invalid password entered - system
locked
20E0000A EEPROM lock problem
20E0000B EEPROM write problem
20E0000C EEPROM read problem
20E00017 Cold boot needed for password
entry
Action / Possible Failing FRU
The password has been entered incor-
rectly.
Retry installing the password.
The password has been entered incor-
rectly.
Retry installing the password.
The privileged-access password jumper is
not in the correct position for password
initial entry.
Consult the system's User's Guide for
jumper location and position.
Unattended mode requires the setting of
the Power On password before it is
enabled.
1. Replace battery
2. Replace I/O board (See notes on 3-1.)
1. Turn off, then turn on system unit.
2. Replace the I/O board (See notes on
3-1.)
Check your machine for evidence of
tampering.
If no tampering evident:
1. Replace battery, restore NVRAM data
(passwords, startup data).
2. Replace I/O board. (See notes on
3-1.)
The password has been entered incor-
rectly 3 times.
Turn off, then turn on the system unit,
then enter the password correctly.
If for privileged-access password install, is
jumper in correct position?
Consult the system's User's Guide for
jumper location and position.
1. Turn off, turn on system unit.
2. Replace I/O board (See notes on 3-1.)
1. Turn off, turn on system unit.
2. Replace I/O board (See notes on 3-1.)
1. Turn off, turn on system unit.
2. Replace I/O board (See notes on 3-1.)
Turn off, turn on system unit.
Chapter 3. Error Code to FRU Index
3-3