IBM H Series Installation And Service Manual page 115

Table 3-1 (Page 6 of 40). Firmware Error Codes.
Error Code Description
21A00003 Send Diagnostic Failed
21A00004 Send Diagnostic Failed - DevOfl
cmd
21E00xxx SCSI Tape
21ED0xxx SCSI Changer
21EE0xxx Other SCSI device type
21F00xxx SCSI CD-ROM
21F20xxx SCSI Read/Write Optical
25000000 Memory Controller Failed.
25010xxx Flash Update Problem
25010000 No diskette in drive
25010001 Diskette seek error
25010002 Diskette in drive does not contain an
*.IMG file
25010003 Cannot open OPENPROM package
25010004 Cannot find OPENPROM node
25010006 System id does not match image
system id
25010007 Image has bad CRC
25010008 Flash is write protected, update can-
celled
25010009 Flash module is unsupported or not
recognized
2501000A Flash write protected
Action / Possible Failing FRU
Refer to the notes in error code
21A000xxx.
Replace the SCSI device.
Refer to the notes in error code
21A000xxx.
Replace the SCSI device.
Refer to 21A00xxx for a description and
repair action for the xxx value.
Refer to 21A00xxx for a description and
repair action for the xxx value.
Refer to 21A00xxx for a description and
repair action for the xxx value.
Refer to 21A00xxx for a description and
repair action for the xxx value.
Refer to 21A00xxx for a description and
repair action for the xxx value.
Replace the system board.
Insert diskette containing firmware image.
1. Retry function.
2. Replace diskette drive.
3. Replace diskette cable.
4. Replace I/O board. (See notes on
3-1.)
Insert diskette with firmware update file.
Replace I/O board (See notes on 3-1.)
Replace I/O board (See notes on 3-1.)
Make sure correct firmware update
diskette is being used with this system.
Replace firmware updated diskette.
1. Turn off, turn on system unit and retry.
2. Replace I/O board. (See notes on
3-1.)
Make sure correct firmware update
diskette is being used with this system.
1. Turn off, turn on system unit, retry.
2. Replace I/O board (See notes on 3-1.)
Chapter 3. Error Code to FRU Index
3-7