IBM H Series Installation And Service Manual page 416

Sample File modem_f0.cfg
#
# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F
#
# FUNCTIONS: Modem configuration file for many recent Hayes compatible modems.
# This example uses the AT&F reset command to choose the factory defaults.
# This set up is preferred for modems with extended (&) commands. For early
# vintage modems, setup Z or Z is recommended. If your modem responds to
# the extended (&) commands and to factory default choices (&Fn), but doesn't
# work properly with this setup file, setup F1 is recommended.
#
# Trademark of Hayes Microcomputer Products, Inc.
#
# (C) COPYRIGHT International Business Machines Corp. 1996
# All Rights Reserved
# Licensed Materials - Property of IBM
#
# US Government Users Restricted Rights - Use, duplication or
# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
#
#
# If the modem has configuration switches, they should be set to the
# factory default settings.
ICDelay 1
DefaultTO 1
CallDelay 12
# AT Attention Code
# &F Reset. Restore profile
# E Turn echo off
# V Use numeric responses
# +++ Escape to command mode
# H Hang-up
#
#
#
#
# &C1 Detect CD
# &R1 Ignore RTS (CTS)
#
# %N Call-Out phone number
# %S Modem speed (available to users)
#
# Following are common responses from a wide range of modems:
# 16, 15, 12, 1 , 5 and 1 are connection responses. Add others as required.
# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; =OK
#
# PROGRAMMING NOTE: No blanks between double quote marks (").
condout: send "AT&F Q T\r"
ignore " \r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATE T\r"
expect " \r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQ V X T\r"
expect " \r" timeout 2
send "ATS = \r"
expect " \r" timeout 2
send "AT&C1&D2&R1\r"
expect " \r" timeout 2
done
connect: send "ATDT%N\r"
E-22
RS/6000 Enterprise Server Model H Series Installation and Service Guide
, Inserts delay in dialing commands
Q Turn on responses
Q1 Turn off responses
S = Automatic answer inhibit
S =2 Answer on second ring
X = Limit modem response codes
T = Tone mode. When used as T\r, it is a
no op to maintain program synchronization
when modem may/will echo the commands.
&D2 Respond to DTR (often the default)
%P Paging phone number
# Reset modem. Select profile
# Initialize modem: Echo OFF,
# Limit response codes.
# Confirm commands successful.
# Set AutoAnswer OFF
# Confirm command successful.
# Detect carrier and DTR,
# Ignore RTS.
# Confirm command successful.
# Tone dialing command.
# %N from Call Home setup.
# Expect a connection response.