IBM H Series Installation And Service Manual page 137

Table 3-1 (Page 28 of 40). Firmware Error Codes.
Error Code Description
40111092 A low 3.3 voltage reading detected
401110A2 A low +5 standby voltage reading
detected
A low +12 voltage reading detected
401110B2
A low −12 voltage reading detected
401110C2
401110D2 A low +5 standby voltage reading
detected
Action / Possible Failing FRU
1. Remove processor card in processor
card connector #2 (if installed) and
see if the problem is resolved. If
problem is resolved replace processor
card. If not, continue.
2. Exchange processor card in processor
card connector #1 with the processor
card removed in step 1 (or replace
processor card if only one processor
card exists) and see if problem is
resolved. If problem is resolved
replace processor card. If not, con-
tinue.
3. Power supply.
1. Remove processor card in processor
card connector #2 (if installed) and
see if the problem is resolved. If
problem is resolved replace processor
card. If not, continue.
2. Exchange processor card in processor
card connector #1 with the processor
card removed in step 1 (or replace
processor card if only one processor
card exists) and see if problem is
resolved. If problem is resolved
replace processor card. If not, con-
tinue.
3. Power supply.
1. Power supply.
2. I/O board (See notes on 3-1.)
1. Power supply.
2. I/O board (See notes on 3-1.)
1. Remove processor card in processor
card connector #2 (if installed) and
see if the problem is resolved. If
problem is resolved replace processor
card. If not, continue.
2. Exchange processor card in processor
card connector #1 with the processor
card removed in step 1 (or replace
processor card if only one processor
card exists) and see if problem is
resolved. If problem is resolved
replace processor card. If not, con-
tinue.
3. Power supply.
Chapter 3. Error Code to FRU Index
3-29