IBM H Series Installation And Service Manual page 419

Sample File modem_f1.cfg
#
# COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F1
#
# FUNCTIONS: Modem configuration file for many recent Hayes compatible modems.
# This example uses the AT&F1 reset command to choose the factory defaults.
# This set up is for modems with extended (&) commands and which do not work
# properly with setup F . For early vintage modems, setup Z or Z is
# recommended.
#
# Trademark of Hayes Microcomputer Products, Inc.
#
# (C) COPYRIGHT International Business Machines Corp. 1996
# All Rights Reserved
# Licensed Materials - Property of IBM
#
# US Government Users Restricted Rights - Use, duplication or
# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
#
#
# If the modem has configuration switches, they should be set to the
# factory default settings.
ICDelay 1
DefaultTO 1
CallDelay 12
# AT Attention Code
# &F1 Reset. Restore profile 1 Q
# E Turn echo off
# V Use numeric responses
# +++ Escape to command mode
# H Hang-up
#
#
#
#
# &C1 Detect CD
# &R1 Ignore RTS (CTS)
#
# %N Call-Out phone number
# %S Modem speed (available to users)
#
# Following are common responses from a wide range of modems:
# 16, 15, 12, 1 , 5 and 1 are connection responses. Add others as required.
# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; =OK
#
# PROGRAMMING NOTE: No blanks between double quote marks (").
condout: send "AT&F1Q T\r"
ignore " \r" or "OK\r\n" timeout 2 # Ignore modem response.
send "ATE T\r"
expect " \r" or "OK\r\n" timeout 2 # Enable responses (Numeric),
send "ATQ V X T\r"
expect " \r" timeout 2
send "ATS = \r"
expect " \r" timeout 2
send "AT&C1&D2&R1\r"
expect " \r" timeout 2
done
connect: send "ATDT%N\r"
expect "16\r" or "15\r" or "14\r" or "12\r" or "1 \r" or "5\r" or "1\r" busy "7\r"
, Inserts delay in dialing commands
Turn on responses
Q1 Turn off responses
S = Automatic answer inhibit
S =2 Answer on second ring
X = Limit modem response codes
T = Tone mode. When used as T\r, it is a
no op to maintain program synchronization
when modem may/will echo the commands.
&D2 Respond to DTR (often the default)
%P Paging phone number
# Reset modem. Select profile 1
# Initialize modem: Echo OFF,
# Limit response codes.
# Confirm commands successful.
# Set AutoAnswer OFF
# Confirm command successful.
# Detect carrier and DTR,
# Ignore RTS.
# Confirm command successful.
# Tone dialing command.
# %N from Call Home setup.
# Expect a connection response.
Appendix E. Modem Configurations
E-25