IBM H Series Installation And Service Manual page 47

Step 1240-2
1. Turn the power off.
2. Remove the memory card from slot J12 (Model H50) or J3 (Model H70).
3. Turn the power on.
Does the system stop with a memory checkpoint displayed on the operator
panel?
NO Go to "Step 1240-4" on page 2-14.
YES Go to "Step 1240-3."
Step 1240-3
1. Turn the power off.
2. Remove the memory card from slot J13 (Model H50) or J2 (Model H70).
3. Install the memory card removed from slot J12 or J3 in its original location.
4. Turn the power on.
Does the system stop with a memory checkpoint displayed on the operator
panel?
NO Tag the memory card you removed from slot J13 or J2 "suspect bad" and
go to "Step 1240-7" on page 2-15.
YES Go to "Step 1240-6" on page 2-15.
Chapter 2. Maintenance Analysis Procedures
2-13