Table of Contents
Advertisement
Replacement
1. Attach the metal plate to the replacement drive.
2. Attach the interposer that you removed earlier to the replacement drive.
3. Connect the power and signal cables to the drive you are installing, making sure
that the correct cables are connected to each drive.
4. Slide the drive into the media bay. You may need to arrange the cables at the
rear of the drive while sliding the it into the bay to prevent any pinching of the
cables.
5. Place the drawer in the front operating position, as described in "Front Operating
Position" on page 7-61.
Chapter 7. Removal and Replacement Procedures
7-63
Advertisement
Chapters
Table of Contents
