IBM H Series Installation And Service Manual page 158

Table 3-7 (Page 2 of 3). Model H70 Service Processor Checkpoints
Checkpoint
E044
E045
E060
E061
E070
E072
E075
E076
D D D E080
D D
D D
D
D
D
D
D
D
D
D
D
D
D
D
E0A0
E0B0
E0C0
E0D0
E0E0
3-50
RS/6000 Enterprise Server Model H Series Installation and Service Guide
Description
Preparing to set serial port line
speed
Preparing to initialize serial port
Preparing to auto power-on (AC
restored)
Preparing to auto power-on (Timer)
Configuring modem
Preparing to call home
Entering SP menus
Leaving SP menus; attempting to
disconnect modems
Entering service processor emer-
gency firmware flash recovery
process.
Beginning Bring-Up Phase
Starting CPU BIST
Starting X5 BIST
Creating JTAG scanlog (failure diag-
nostic information)
Pulling CPU out of reset
Action/
Possible Failing FRU
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. Modem.
2. I/O board. (See notes on 3-1.)
3. CPU Card.
1. Modem.
2. I/O board. (See notes on 3-1.)
3. CPU Card.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. Insert a new DOS-formatted
diskette containing the service
processor firmware update into
the diskette drive. The firmware
image must be named
spflash.img.
Note: Insert the diskette only
after checkpoint E080
displays.
2. Cycle ac power and retry the
flash recovery.
3. Cycle the ac power again with
another new diskette and retry
the flash recovery.
4. Replace the I/O board.
1. I/O board. (See notes on 3-1.)
2. CPU Card.
1. CPU Card.
2. I/O board. (See notes on 3-1.)
1. CPU Card.
2. I/O board. (See notes on 3-1.)
N/A--wait for completion
1. CPU Card.
2. I/O board. (See notes on 3-1.)