IBM H Series Installation And Service Manual page 161

Table 3-8 (Page 2 of 10). Firmware Checkpoints.
Checkpoint Description
E116 BAD CRC - copy recovery block
data section to RAM
E117 BAD CRC - Invalidate and flush
cache, set TOC
E118 BAD CRC - branch to high level
recovery control routine.
E119 Initialize base memory, stack
E11A Copy uncompressed recovery block
code to RAM
E11B Jump to code in RAM
E11C Turn on cache
E11D Copy recovery block data section to
RAM
E11E Invalidate and flush cache, set TOC
E11F Branch to high level control routine.
E120 Initialize I/O and early memory block
E121 Initialize service processor
E122 No memory detected (system
lockup) Note: Disk drive light is on
continuously.
E123 No memory module found in socket.
E124 Disable defective memory bank
E125 Clear PCI devices command reg, go
forth
E126 Check valid image - start
E127 Check valid image - successful
E128 Disable interrupts, set interrupt
vectors for Open Firmware.
E129 Validate target RAM address
E12A Copy ROM to RAM, flush cache
E12B Set MP operational parameters
E12C Set MP CPU node characteristics
E12D Park secondary processors in
parking lot
E12E Primary processor sync
E12F Unexpected return from Open
Firmware (system lockup)
Action/
Possible Failing FRU
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
Go to "MAP 1240: Memory Problem
Resolution" on page 2-10.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
See the note on 3-45.
Chapter 3. Error Code to FRU Index
3-53