IBM H Series Installation And Service Manual page 86

Step 1540-14
The system is working correctly with this configuration. One of the disk drives that
you removed from the hot-swap bay may be defective.
1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive.
2. Turn the power off and remove the power cable.
3. Install a disk drive in the hot-swap bay.
4. Plug in the power cable and wait for OK on the operator panel display.
5. Turn the power on.
6. After the keyboard indicator is displayed, press the F5 key on the directly-
attached keyboard or the number 5 key on an ASCII terminal keyboard.
7. Enter the appropriate password if prompted to do so.
Is the "Please define the System Console" screen displayed?
NO In the following order, exchange the FRUs that have not been exchanged:
1. Last disk drive installed
2. Hot-swap bay backplane
Repeat this step until the defective FRU is identified or all the FRUs have
been exchanged.
If the symptom did not change and all the FRUs have been exchanged,
call your service support person for assistance.
If the symptom has changed, check for loose cards, cables, and obvious
problems. If you do not find a problem return to "Step 1540-1" on
page 2-38 in this MAP and follow the instructions for the new symptom.
YES Repeat this step until all the disk drives are installed.
Go to "Step 1540-15" on page 2-53.
2-52
RS/6000 Enterprise Server Model H Series Installation and Service Guide