Configuring The Cisco Spa500S - Cisco SPA303 Administration Manual

Configuring the Cisco SPA500S Attendant Console
Setting Up the Cisco SPA500S Attendant Console
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
This is entered in the file sip.conf:
[3500]
type=friend
secret=3500
callerid="spa3500"<3500>
nat=no
context=home
mailbox=3500
Subscribecontext=home
...
...

Configuring the Cisco SPA500S

Complete the configuration required for the extensions on your IP PBX and obtain
the following information:
• IP PBX IP address or other hostname
• Phone extension numbers
To configure the Cisco SPA500S:
Steps 1 through 4 are only required when the
These steps are not required for other server types such as BroadSoft and
Asterisk.
Connect to the configuration utility for the phone to which the Cisco SPA500S is
connected.
Click Admin/Advanced on the configuration utility page.
Click the SIP tab.
Select yes from the CTI Enable
Click the Attendant Console tab.
Unit 1 Enable
Select yes from the
SPA500S units, also select yes from the
Server Type
drop-down list.
drop-down list. If you have installed two Cisco
Unit 2 Enable
field is set to SPA9000.
drop-down list.
9
213