Configuring The Cisco Unified Wireless Lan Controller And Access Points - Cisco 8800 Series Deployment Manual

For more information on these features, see the Cisco IP Phone 8800 Series Administration Guide or the Cisco IP Phone 8800
Series Release Notes.
http://www.cisco.com/c/en/us/support/collaboration-endpoints/unified-ip-phone-8800-series/products-maintenance-guides-
list.html
http://www.cisco.com/c/en/us/support/collaboration-endpoints/unified-ip-phone-8800-series/products-release-notes-list.html
Configuring the Cisco Unified Wireless LAN Controller and Access
Points
When configuring the Cisco Unified Wireless LAN Controller and Access Points, use the following guidelines:
Ensure 802.11r (FT) or CCKM is Enabled
•
Set Quality of Service (QoS) to Platinum
•
Set the WMM Policy to Required
•
Ensure Session Timeout is enabled and configured correctly
•
Ensure Aironet IE is Enabled
•
Set DTPC Support to Enabled
•
Disable P2P (Peer to Peer) Blocking Action / Public Secure Packet Forwarding (PSPF)
•
Ensure Client Exclusion is configured correctly
•
Disable DHCP Address Assignment Required
•
Set MFP Client Protection to Optional or Disabled
•
Set the DTIM Period to 2
•
Set Client Load Balancing to Disabled
•
Set Client Band Select to Disabled
•
Set IGMP Snooping to Enabled
•
Enable Symmetric Mobile Tunneling Mode if Layer 3 mobility is utilized
•
Enable Short Preamble if using 2.4 GHz
•
Enable ClientLink if utilizing Cisco 802.11n/ac Access Points
•
Configure the Data Rates as necessary
•
Enable CCX Location Measurement
•
Configure Auto RF as necessary
•
Set Admission Control Mandatory to Enabled for Voice
•
Set Load Based CAC to Enabled for Voice
•
Enable Traffic Stream Metrics for Voice
•
Set Admission Control Mandatory to Disabled for Video
•
Set EDCA Profile to Voice Optimized or Voice and Video Optimized
•
Set Enable Low Latency MAC to Disabled
•
Cisco IP Phone 8800 Series Wireless LAN Deployment Guide
Line/Button configured will be display on one KEM.
51