Cisco SPA303 Administration Manual page 146

Configuring Security, Quality, and Network Features
Setting Optional Network Parameters
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
Primary DNS
Secondary DNS
DNS Server Order
DNS Query Mode
Syslog Server
Debug Server
Debug Level
Description
DNS server used by the phone in addition to DHCP
supplied DNS servers if DHCP is enabled; when DHCP
is disabled, this is the primary DNS server.
Defaults to 0.0.0.0.
However, if using LDAP, see
Directory Access Protocol (LDAP) for the Cisco
SPA300 Series and Cisco SPA500 Series IP Phones,
page 85.
DNS server used by the phone in addition to DHCP
supplied DNS servers if DHCP is enabled; when DHCP
is disabled, this is the secondary DNS server.
Defaults to 0.0.0.0.
Specifies the method for selecting the DNS server. The
options are Manual, Manual/DHCP, and DHCP/Manual.
Do parallel or sequential DNS Query. With parallel DNS
query mode, the phone sends the same request to all
the DNS servers at the same time when doing a DNS
lookup, the first incoming reply is accepted by the
phone.
Defaults to parallel.
Not available on WIP310 or SPA525G/525G2.
Specify the syslog server name and port. This feature
specifies the server for logging system information and
critical events. If both Debug Server and Syslog Server
are specified, Syslog messages are also logged to the
Debug Server.
The debug server name and port. This feature
specifies the server for logging debug information. The
level of detailed output depends on the debug level
parameter setting.
The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
5
Configuring Lightweight
144