Rear Panel - Asko T700 Service Manual

SERVICE

REAR PANEL

Removing the rear panel
1. Remove the 3 screws at the rear of the top
cover and lift it off.
2. Unscrew the centring nut until the face of the
nut is level with the end of the thread and
knock out the bearing.
3. Fit the special tool (part no. 88 011 54) by
fitting the tube end into one of the stamped
out keyholes in the front rail. Lift the rear edge
of the drum and press the drum edge on to
the roller.
4. Remove the earth connection (yellow/green
wire) from the input terminal block.
5. Take the cable bundle out of the cable clamp
and pull the header block off its terminal pins.
6. Remove the wiring:
T700/720: R1 a, R1 b, R1 13, R1 14, R1 34
on the contactor.
T760/780: Ra, Rb, R13, R14, R34 on the
contactor and F3 and F4 on the radio interfe-
rence filter.
7. T720/780: Remove the hoses to the water
tank housing.
8. Remove the centring nut and the 8 screws.
9. T720/780: Remove the 3 plastic screws.
10. Lift off the rear panel.
Installing the rear panel
11. Hook the rear panel on to the base.
12. Remove the special tool.
13. Screw on the centring nut and fit the 8 screws.
14. T720/780: Refit the hoses.
15. Fit the earth connection and the wiring:
T700/720: R1 a, R1 b, R1 13, R1 14, R1 34
on the contactor.
T760/780: Ra, Rb, R13, R14, R34 on the
contactor and F3 and F4 on the radio interfe-
rence filter.
16. Push the header block on to its terminal pins
and place the cable bundle in the cable clamp.
17. Fit the top cover.
IMPORTANT
Don't forget the 2 star washers for the outermost
screws.
34
3
6
4
5
2,8
9
8