Ch An G I N G Th E Fo Am Ru Bber Seal - Asko T7OO Series Service Manual

https://appliancetechmanuals.com
INNER AND OUTER REAR PANELS AND FOAM RUBBER SEAL
REM O V I N G TH E I N N ER AN D O U TER REM O V I N G TH E I N N ER AN D O U TER REM O V I N G TH E I N N ER AN D O U TER REM O V I N G TH E I N N ER AN D O U TER REM O V I N G TH E I N N ER AN D O U TER
REAR P REAR P REAR PAN ELS REAR P REAR P AN ELS AN ELS AN ELS AN ELS
1. Remove the top cover (see page 23) and the rear
panel (see page 26).
2. Remove the screws and the cable clamp that
secure the inner rear panel to the outer panel.
3. Lift them apart. T he bearing is now free and
can be removed.
Screws
P/N 8900338
Outer rear panel
P/N 8061829
REPLACI N G TH E I N N ER AN D O U TER REPLACI N G TH E I N N ER AN D O U TER REPLACI N G TH E I N N ER AN D O U TER REPLACI N G TH E I N N ER AN D O U TER REPLACI N G TH E I N N ER AN D O U TER
REAR P REAR P REAR PAN ELS REAR P REAR P AN ELS AN ELS AN ELS AN ELS
4. Put the inner rear panel on to the drum shaft
and feed it on to the bearing.
5. Align the outer rear panel and secure it with the
screws to the inner rear panel, along with the
cable clamp.
W ARN I N G W ARN I N G W ARN I N G
W ARN I N G W ARN I N G
It is important that the wiring bundle runs along
its groove.
26
Inner rear panel
P/N 8061851
6. Secure the rear panel to the side panels and
bottom.
7. Install the remaining wiring in accordance with
the electrical schematic diagram.
8. Replace the top cover. Don't forget the two star
washers for the outer screws.
9. Tighten the centering nut.

CH AN G I N G TH E FO AM RU BBER SEAL

CH AN G I N G TH E FO AM RU BBER SEAL CH AN G I N G TH E FO AM RU BBER SEAL CH AN G I N G TH E FO AM RU BBER SEAL CH AN G I N G TH E FO AM RU BBER SEAL
1. Remove the cover (see page 23) and the rear panel
(see page 26).
2. Remove the screws that secure the rear panel sides
and bottom.
3. Remove the screws that secure the inner and
outer rear panels.
4. Lift off the outer rear panel.
5. Change the foam rubber seal.
6. Put the outer rear panel in place.
7. Secure the rear panels to each other.
8. Secure the rear panels to the machine.
9. Replace the top cover. Don't forget the two star
washers for the outer screws.
Foam rubber seal
P/N 8003576