Hunt Group Opening And Closing - Aastra DT390 User Manual

To manage your group standby status, from an idle extension, do the
following:
1. Dial 6 8 to proceed to standby within your primary group.
2. Press
3. Press
Note:
13.4

Hunt Group Opening and Closing

You may be designated as a supervisor for one or several hunt groups,
regardless of whether or not you are a member of it (them). This is
established by a right that is assigned specifically to you by your system
administrator. In relation to this (these) hunt group(s) for which you are in
charge, it is your responsibility to open and close traffic for each one,
according to its members' business hours.
To open or close traffic to a hunt group, from an idle extension, do the
following:
1424_EN_LZT103089 Rev B1 2009-05-20
.
Wait for the Service Acceptance Tone.
If your extension was active within your primary group, it will now be on
standby. On the other hand, if your extension was on standby, it will
now be active within your primary group.
In relation to your secondary groups, your extension's active or inactive
status is changed for all of them at the same time. In either case the
service acceptance tone is played.
to finish the procedure.
Your extension returns to idle status.
The prefix for accessing the standby service within secondary
groups differs from one facility to another. You may place your
extension on standby at any time, even if you are the last active
member of a group. Your status is managed completely
independently from the opening and closing of traffic for a specific
group, which is the sole responsibility of the hunt group
supervisor.
1. Dial the prefix to open/close hunt groups.
This varies from one facility to another.
2. Dial the internal number for the involved hunt group.
3. Press .
Wait for the Service Acceptance Tone.
4. Press to end this service.
© Copyright Aastra Telecom Sweden, 2009.
All rights reserved.
74