Aastra DT390 User Manual page 57

You may also repeat the procedure from a new recipient extension, in
which case, your calls would follow you as you move from office to office.
This is activated as described below, from an idle, remote extension, which
will be your call forward recipient:
Deactivating Follow-Me service from the DT390 it was activated
1. Dial 6 6, assigned to cancel the Follow me service.
2. Dial your own extension number, and press
3. Enter your user password.
4. Press
5. Wait for the Service Acceptance Tone.
6. Press
Activating Follow-Me from a DT390 phone the calls are not forwarded
to
1. Dial 6 5 *
2. Dial your number and press *.
3. Dial the new number to where incoming calls should be diverted.
4. Press
5. Enter a password.
6. Press
7. Wait for the Service Acceptance Tone.
8. Press
1424_EN_LZT103089 Rev B1 2009-05-20
In terms of the rights assigned to your extension and each
Note:
recipient extension, it is possible that access to the follow me
service is restricted. Therefore, you always have the option of
requesting that a facility attendant define a remote call forward
for your account.
.
Wait for dial tone.
to finish the procedure.
# To dial only in case of an external position. Needed only for an
external position to mark the end of the Directory number.
An external number is composed of the external access 0
Note:
followed by the actual external Directory number.
.
to activate the service.
The third party set confirms your service programming and/or plays the
service acceptance tone.
to finish the procedure.
.
© Copyright Aastra Telecom Sweden, 2009.
All rights reserved.
57