9.8
Call Parking and Retrieving
An ongoing call can temporarily be put on hold. Calls put on hold can be
resumed to your own or on another phone. To put a call on hold, do the
following:
1. Press R.
2. Press 10 to access the call parking service.
3. Dial the identification code for the call you wish to park.
4. Press
9.8.1
Resume a Call
To retrieve a parked call from your extension on a similar idle extension:
1. Press 10 to access to the call parking service.
2. Dial the 1 or 2 digit identification code for the parked call.
3. Press
Note:
9.9
Conference
With the conference function, up to seven parties can be included in a
conference. Only the conference leader (that is, the person initiating the
conference) can admit participants. During the conference a tone will be
heard every 15 seconds. A tone burst is heard each time a participant
enters or leaves the conference. When the conference leader leaves the
conference, the conference will continue with the other included parties.
The conversation is changed back to a normal two party connection when
there is only two parties left.
Note:
When having an ongoing conversation and wanting to establish a phone
conference, do the following:
1424_EN_LZT103089 Rev B1 2009-05-20
Wait for dial tone.
This call identification code will be requested later when you retrieve
the parked call. This code is unrestricted, and may consist of 1 or 2
digits, according to your facility's configuration (usually 2 digits)
to end the service
to return to your conversation.
When an external call is either placed on hold or is parked, the party
is then connected to on-hold music, usually provided by your facility.
The parked call retrieving service may be activated by dialling the
following, from any extension, using the same sequence: 10
<identification code>. Your calls may also be subject to parking by a
third party set.
This feature needs to be configured in the WinPDM or CPDM by
your system administrator.
© Copyright Aastra Telecom Sweden, 2009.
All rights reserved.
47