Audible Signals - Aastra DT390 User Manual

17

Audible Signals

Over and above visual information displayed on your extension's screen
and LED, there are also various tones, voice announcements and ring
tones that signal the status of your extension, or certain associated
services. The tones heard are applicable under the following conditions
and with the following timing and frequency:
Internal Dial tone Heard each time the handset is picked up from your
extension (excluding all activated special services)
330 Hz, Continuous
Ringback tone Heard when you call an extension that is free.
424 Hz, 1.5 sec. On / 3.5 sec. Off
Call on-hold or Call camp-on tone Heard when you call an extension that
is busy and your call has been placed on automatic camp-on, or when your
call is placed onhold by a third party set.
424 H, 2 consecutive beeps, repeated every 5 seconds.
Busy tone Heard when you call an extension that is busy, but automatic
camp-on is not possible for your call, or when a service request on your
extension is refused.
424 Hz, 0.5 sec. On / 0.5 sec. Off
Call Waiting Presentation tone Heard when you receive a new call, when
your extension is already busy.
Only 1 ring signal, not repeated
Intrusion or Call Offer tone Heard when a third party - typically an
attendant - intervenes during your current call.
424 Hz, 2 consecutive beeps, repeated every 1.4 seconds.
Service Acceptance tone Heard when a request for service is accepted
on your extension. Multi-toned melody, continuous
Appointment Reminder notification Heard following your response to an
appointment reminder, this announcement indicates the nature of this
automatic system call. See Section 14. Message: It's time for your
appointment.
1424_EN_LZT103089 Rev B1 2009-05-20
1. Press Menu, select Settings, press Select.
2. Select In charger, and press Select.
3. Mark No action, and press Select.
4. Press Back to save the setting.
© Copyright Aastra Telecom Sweden, 2009.
All rights reserved.
95