Beep After Weigh - Datalogic Magellan 8500Xt Product Reference Manual

RS-232 Beep After Weigh
7-108
Enables/disables the ability of the scanner to beep after weight data is
transmitted to the host. Scale interfaces that support this item are: RS-232
ICL, RS-232 SASI, and RS-232 Single Cable.
To enable/disable the Beep After Weigh feature:
1. Scan the SWITCH barcode.
2. Scan either the enable or disable barcode below. You'll need to
cover any unused barcodes on this and the facing page to ensure
that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
barcode.
BEEP AFTER WEIGH = DISABLE
BEEP AFTER WEIGH = ENABLE
Magellan
TM
8500Xt Scanner