Eas Deactivation Duration - Coupled - Datalogic Magellan 8500Xt Product Reference Manual

EAS Deactivation Duration — Coupled
NOTE
Product Reference Guide
Specifies the amount of time EAS deactivation is operative once the func-
tion has been initiated following a barcode read.
This setting pertains only to units configured for EAS Coupled Mode. Refer-
ence the EAS Mode description for more information about Coupled and
Decoupled EAS operation.
To set the EAS Deactivation Duration — Coupled:
1. Scan the SWITCH barcode.
2. Scan the barcode,
below. You'll need to cover any unused barcodes on this and the fac-
ing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the keypad in
resent the desired duration. The selectable range is 1-255, which is
the duration in 10-millisecond increments. Pad all single and double
digit numbers with leading zeroes to yield a three-digit entry (001-
255).
Examples:
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET EAS DEACTIVATION DURATION — COUPLED
SET EAS DEACTIVATION DURATION — COUPLED
that rep-
Appendix C
7-51