Table of Contents
Advertisement
READING PARAMETERS
A
S
IMING
YSTEM
This parameter sets the duration the aiming pattern is seen before a scan attempt
begins. It is programmable in 0.1 second increments from 0.0 to 9.9 seconds. No aim
pattern is visible when the value is 0.0.
To set the aiming system, scan the barcode below. Next scan the two
Numeric
Barcodes
in Appendix C that correspond to the desired aiming system duration.
Single digit values must be predefined by a leading zero. For example, to set an
aiming system duration of 0.5 seconds, scan the barcode below, then scan the "0"
and "5" barcodes. To change the selection or cancel an incorrect entry, scan the
barcode in Appendix C.
CANCEL
AIMING SYSTEM
B
A
G
D
EEP
FTER
OOD
ECODE
Scan this symbol to set the reader to beep after a good decode.
BEEP AFTER GOOD DECODE
Scan this symbol to set the reader not to beep after a good decode. The beeper still
operates during parameter menu scanning and indicates error conditions.
DO NOT BEEP AFTER GOOD DECODE
23
Advertisement
Table of Contents
