Datalogic Magellan 8500Xt Product Reference Manual page 119

Section 6
Calibration Procedures, Dual Interval
LEGAL NOTE
Product Reference Guide
This section applies to scanner/scale models
with dual interval ONLY.
NOTE
A number of situations require the scale to be calibrated. They are:
• at initial installation of the scanner/scale
• if the scale cannot be rezeroed
• when changing the weight measure from pounds to kilograms or
vice-versa
• if diagnostics indicate a calibration error
• when removing/replacing any scale assembly or the Main Board
• when required by local regulations
Follow the procedures on the following pages to ensure that the scanner/
scale will meet Weights and 
Measurement requirements.
Certification of the scanner/scale's weighing apparatus is subject to
Federal, State and Local Weights and Measures statutes and is
restricted to authorized government agencies and/or duly regis-
tered agents thereof. Anytime a scale is calibrated, it should be
properly sealed with a lead and wire or paper seal before being
placed into service.
It is your responsibility to check with the appropriate authorities in
your area to ensure compliance with pertinent regulations before
removing any official seals or placing a newly calibrated scanner/
scale into service.
6-1