Power-up Beep Control
Product Reference Guide
Specifies the type of audible indication that is made when entering scan-
ner-active mode on power-up. Choices are:
•
No beep
•
One beep
To set the Power-up Beep:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes below. You'll need to cover
any unused barcodes on this and the facing page to ensure that
the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
barcode.
POWER-UP BEEP = OFF
POWER-UP BEEP = ONE BEEP
7-21