Model 960Rd: Placing And Installing The Remote Scale Display - Datalogic Magellan 8500Xt Product Reference Manual

Model 960RD: Placing and Installing the Remote Scale Display

NOTE
Product Reference Guide
(Short Pedestal Base ONLY)
1. Determine where you want to install the Remote Scale Display
based on your counter design, the viewing angle and lighting con-
siderations discussed previously. Reference
play's physical dimensions.
2. Use the short pedestal base template provided in
mark locations of the mounting screw and cable routing holes.
The mounting screw holes are on 3
Before drilling, ensure the holes in your base match with the holes indi-
cated on the template.
3. The cable can either be routed through a
hole directly under the mounting base or through the cutout in
the back of the base (see
4. Drill the mounting screw holes using a drill bit of the appropriate
diameter for your mounting screws or bolts.
5. Drill the cable routing hole using a
(optional).
It may be necessary to shorten the stalk that supports the display head so
that the display is installed at eye level.
Figure 2-16
3
/8" (8.57 cm) centers.
3
/4" (19 mm) diameter
).
Figure 2-20
3
/4" (19 mm) drill bit
for the dis-
to
Figure 2-18
2-31