Datalogic Magellan 8500Xt Product Reference Manual page 87

Product Reference Guide
Gasketed Models
1. Remove the All Weighs™ Platter from the scanner as shown in
.
Figure 3-3
2. Turn the platter upside down on a clean, dry surface and remove
the two screws and two nuts shown in
screws and nuts for later reinstallation.
3. Lift the edge of the retainer shown in
from the assembly.
4. Take note of how the gasket is seated, then gently peel it away
from the assembly as shown in
reinstallation.
5. The window can now be removed (see
pose of any damaged glass.
6. While carefully holding it by its edges, tilt a new horizontal win-
dow fully into position as shown in
7. Fit the gasket into its channel as shown in
around its entire perimeter to ensure it is fully seated.
8. Reinstall the retainer in the orientation shown in
aligning both holes with their studs.
9. Secure the retainer using the original two screws and two nuts as
shown in
Figure 3-6
10. Clean both sides of the new horizontal window using a paper
towel or lint free cleaning tissues dampened with a mild, water-
based glass cleaner. DO NOT use abrasive cleaners or pads.
Reinstall the platter. Gasketed horizontal window replacement is now
complete.
Figure 3-6
Figure 3-6
Figure 3-6
Figure 3-6
Figure 3-6
a.
a. Retain all
b and remove it
c. Retain the gasket for
d). Carefully dis-
d.
c and press
Figure 3-6
b,
Figure 3-6
3-17