Ean 13 Label Id - Datalogic Magellan 8500Xt Product Reference Manual

EAN 13 Label ID

The programming feature, RS-232 Label ID Control, designates
whether the Label ID is transmitted as a prefix or suffix or if Label ID is dis-
abled.
NOTE
Product Reference Guide
This feature specifies an EAN 13 label ID to be added to barcode data.
To set this feature:
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode, SET EAN 13 LABEL ID below. You'll need to
cover any unused barcodes on this and the facing page to ensure
the scanner reads only the barcode you intend to scan.
3. Scan the appropriate digits from the keypad in
represent the desired Label ID characters; entered as two hex
pairs. A table containing the ASCII Character Set and their corre-
sponding Hex Values is available in the inside back cover of this
manual. ASCII parameters must be input by scanning a pair of
hexadecimal digits for each character. Thus, to set a two-character
value of AB, barcodes containing the digits '4', '1', '4', and '2'
must be scanned. The selectable range for this option is any hex
value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
barcode.
SET EAN 13 LABEL ID
that
Appendix C
7-157