What To Do In Case Of Power Failure; Power Failure; Failures Of Ecr As A Result Of Interference In Power Network; Signalization Of Internal Accumulator Conditions - ELCOM Euro-2100TE User Manual

Helpful advice
LowBAT, finish sale
Very low battery
RESET CODE
Battery checking
Perform PLU report
Perform DPT report
Perform clerk report
BAD PSW
Perf. hour.rep.daily
Perf.hour.rep.period
JOURNAL CONTENT FULL
PRINT JOURNAL
JOURNAL DAMAGED
JOURNAL FULL FOR 80%
JOURNAL FULL FOR 90%
JOURNAL ALMOUST FULL
TEAR OFF RECEIPT
AND PRESS SUBTOTAL KEY

WHAT TO DO IN CASE OF POWER FAILURE?

Power failure

This part is important only for registers that operate without the built-in accumulator.
If you have used the cash register and a power failure occurs, it is necessary:
• to switch the cash register off
• after electric power recovery switch the cash register on
• if the register displays the text Continue on Sale it is necessary to complete the purchase and com-
pare the resulting sum with the total of registered items within the purchase; if one of the items has
not been added to the total sum of the purchase but it was sold to the customer it is necessary to
register it additionally.

Failures of ECR as a result of interference in power network

Accidental failures of electronic equipment are frequently caused by the power network or by electromag-
netic interference. In case of intensive interference in your working area, or in case of over or under voltage,
installation of protective devices can help significantly. Ask your authorised dealer or service technician for
help.

Signalization of internal accumulator conditions

The status of internal accumulator charge defines the percentage value in the upper left corner of the
cashier display. This percentage value informs also that power supply of the ECR is internal accumulator
(the external adapter is not connected). In the case the charge is low (low percentage value) the ECR dis-
plays the text Low BAT., finish sale for a short time and peeps alerting tone.
92
It is shown when receipt it printing, when it is needed bigger power input.
Connect ECR to power supply with external adapter.
Connect ECR to power supply with external adapter.
Memory can be damaged. Call for service.
Checking battery condition.
While switching to the second Euro phase. Perform „Z" PLU report.
While switching to the second Euro phase. Perform „Z" DPT report
While switching to the second Euro phase. Perform „Z" cashiers report.
Password was not find in list of cashiers passwords.
Message is shown when you trying to perform Hours periodical report without
Hours daily report performed.
Message is shown when you trying to switch into the second Euro phase
without Hours periodical report performed.
Print out the electronic journal to release occupied memory.
PC data in ECR memory are damaged.
Journal is full up to 80%.
Journal is full up to 90%.
Journal is full up to 95, it is necessary to print the journal as soon as possible,
since after journal fills up to 98, it is impossible to start another receipt.
Get ready for electronic journal printing.