Initialisation; Recommended Procedure For Euro-2100Te Programming; System Flags Programming; Initial Programming Of System Flags - ELCOM Euro-2100TE User Manual

Programming manual

INITIALISATION

Before putting the cash register into operation, it must be initialised. The cash register initialisation clears all
programmed data and will return the ECR to default settings. Only following data will be preserved: grand
totals, report numbers (Z1 and Z2) and value of system flag no. 1. ECR initialisation is possible only if daily
and periodical reports have been issued in "Z" mode and el. journal has to be printed out.
Initialisation procedure:
1) Turn the cash register on and press
P

2) Press button. The "
MEMORY CLEARING
P
3) To confirm the initialisation, press the
clearing
4) After initialisation enter the date (DDMMYY) and time (HHMM).

RECOMMENDED PROCEDURE FOR EURO-2100TE PROGRAMMING

The recommended procedure for ECR programming advises an user to program the ECR in the following
order: 1) system flags, 2) tax levels, 3) extended flags 4) receipt logo, 5) cashiers, 6) function texts, 7) de-
partments, 8) sale units and finally 9) article items (PLUs).

SYSTEM FLAGS PROGRAMMING

Prior to programming of the ECR, it is recommended that this sub chapter is carefully studied and clearly
understood.
Note: If a key is used for two functions, choose the function in a lower part of a key by pressing the key. To
choose the function in the upper part of a key, hold the

Initial programming of system flags

The system flags represent settings that have primary influence on the proper performance of ECR (number
of decimal places, rounding, date, time, etc.).
System flags programming procedure:
1) Switch the cash register into the "P" mode by pressing
bottom on the display). Only a cashier authorised for the programming mode can set the ECR into
the "P" mode.

2) Press
26
02-02-2005
19:05:33
Memory clearing
10:21:09
" and it begins the initialisation.
ENTER DATE
(RA) buttons.
002222
SF1:

to enter "P" mode.
" label appears on the display.

(S ) button. The ECR printer prints "
UBTOTAL

(S ) key and press the particular key.
HIFT

ENTER TIME
. On the display appears „
Memory
P
" (left