What To Do In Case Of Power Failure; Power Failure - ELCOM Euro-200TE User Manual

Helpful advice
RESET CODE
Battery checking
Perform PLU report
Perform DPT report
Perform clerk report
BAD PSW
Perf. hour.rep.daily
Perf.hour.rep.period
JOURNAL CONTENT FULL
PRINT JOURNAL
JOURNAL DAMAGED
JOURNAL FULL FOR 80%
JOURNAL FULL FOR 90%
JOURNAL ALMOUST FULL
TEAR OFF RECEIPT
AND PRESS SUBTOTAL KEY
DON'T TURN OFF ECR!
UPDATING..
CC COMM.ERROR XX
CC FELAKTIGT KASSAID
INCORRECT POS ID
CC FATAL ERROR
CC upptagen. Försöka igen?
CleanCash is busy. Repeat?
CC FUNGERAR EJ
CC NOT OPERATIONAL
CC INTERNT FEL
CC INTERNAL ERROR
CC OKÄNT FEL
CC UNKNOWN ERROR
CC COMM.SEQUENCE ERR
ECR <-> CC

WHAT TO DO IN CASE OF POWER FAILURE?

Power failure

Power failure does not affects functionality of Euro-200TE, because this cash register is equipped with
internal accumulator.
110
Memory can be damaged. Call for service.
Checking battery condition.
While switching to the second Euro phase. Perform „Z" PLU report.
While switching to the second Euro phase. Perform „Z" DPT report
While switching to the second Euro phase. Perform „Z" cashiers report.
Password was not find in list of cashiers passwords.
Message is shown when you trying to perform Hours periodical report without
Hours daily report performed.
Message is shown when you trying to switch into the second Euro phase
without Hours periodical report performed.
Print out the electronic journal to release occupied memory.
PC data in the cash register memory are damaged.
Journal is full up to 80%.
Journal is full up to 90%.
Journal is full up to 95, it is necessary to print the journal as soon as possible,
since after journal fills up to 98, it is impossible to start another receipt.
Get ready for electronic journal printing.
Proceeding of software update, don't stop the cash register !
Failure of communication between the cash register and CleanCash. XX re-
presents internal failure number of communication. The device is not con-
nected or the communication settings are not correct. If this message will
be displayed after checking the settings and communication cable, contact
service.
Incorrect ECR number (from 3rd system flag). Synchronize the cash register
number from the cash register with that from CleanCash.
Failure of CleanCash, call service.
The CleanCash is preceding data synchronization which is not allowing res-
ponding the cash register request. Wait until the CleanCash will finish or can-
cel operation at the cash register. By pressing key [ST] the cash register will
repeat operation and repeat communication with CleanCash.
CleanCash failure, call service.
CleanCash failure, call service.
Unknown error message send from CleanCash, call service.
Internal failure of communication with CleanCash, call service.
Proceeding of the cash register and CleanCash data transfer.