What To Do In Case Of Power Failure; Power Failure; Failures Of Ecr As A Result Of Interference In Power Network; Signalization Of Internal Accumulator Conditions - ELCOM Euro-200T User Manual

Helpful advice
LowBAT, finish sale
Very low battery
RESET CODE
Battery checking
Perform PLU report
Perform DPT report
Perform clerk report
BAD PSW
Perf. hour.rep.daily
Perf.hour.rep.period

WHAT TO DO IN CASE OF POWER FAILURE?

Power failure

Power failure does not affects functionality of Euro-200T/TX, because this ECR is equipped with internal
accumulator.

Failures of ECR as a result of interference in power network

Accidental failures of electronic equipment are frequently caused by the power network or by electromag-
netic interference. In case of intensive interference in your working area, or in case of over or under voltage,
installation of protective devices can help significantly. Ask your authorised dealer or service technician for
help.

Signalization of internal accumulator conditions

The status of internal accumulator charge defines the percentage value in the upper left corner of the
cashier display. This percentage value informs also that power supply of the ECR is internal accumulator
(the external adapter is not connected). In the case the charge is low (low percentage value) the ECR dis-
plays the text Low BAT., finish sale for a short time and peeps alerting tone.
If the internal accumulator is very discharged and you want to charge it by the external adaptor, first of all
be sure that ECR is turned off, then connect the external adapter for at least 15 minutes (ECR is off). The
internal accumulator is charging even the ECR is turned off.
Care of internal battery:
• a complete battery charge takes 8 hours.
• we suggest to charge a battery to 100 % and use it till cash register starts to signalize the battery char-
ge requirement. Repeat this process three times at least (it elongates an endurance of the battery).
• we suggest to change the battery in case of the battery decrease, e. g. shorter work cycle of the
ECR after a battery charge.

SELF TESTS

Self tests of the Euro-200T/TX cash register permit the checking of its functionality simply and quickly. Self
testing permits the automatic checking of the functionality of electronic circuits, display segments, keyboard
buttons, communication ports and the printer.
88
It is shown when receipt it printing, when it is needed bigger power input.
Connect ECR to power supply with external adapter.
Connect ECR to power supply with external adapter.
Memory can be damaged. Call for service.
Checking battery condition.
While switching to the second Euro phase. Perform „Z" PLU report.
While switching to the second Euro phase. Perform „Z" DPT report
While switching to the second Euro phase. Perform „Z" cashiers report.
Password was not find in list of cashiers passwords.
Message is shown when you trying to perform Hours periodical report without
Hours daily report performed
Message is shown when you trying to switch into the second Euro phase
without Hours periodical report performed.