Table of Contents
Advertisement
Programming manual
3
0
4
0
5
0
Seventh extended flag
Figure 3.17. Seventh extended flag values
Digit
Default setting
1
0
Printing of the extended flag values
In the programming mode, select extended flags programming by pressing the
After pressing the
cular flag only by pressing the
TAX RATES PROGRAMMING
The cash register allows the use of six tax rates plus one rate without tax. Both the tax rate and its name are
programmable. The seventh rate is not programmable.
Tax level programming procedure:
1) Switch the ECR into the programming mode "P" by pressing
2) Press the
3) Enter the tax rate without decimal point. First two numerals compose integer part of the rate, last
two compose decimal part (i. e. for tax rate of 19% it is 1 9 0 0). The tax rate can be changed only
after daily and periodical report have been executed in "Z" report mode. If you need to disable
a specific tax level, programme its tax rate as 100.00% or higher.
4) Press the
5) To exit the tax level programming, press
More details on entering texts are located at the end of this chapter.
32
Printing format and storing format in the PC journal
if ECR reads and successfully looks up the 13+5
bar-code
Printing format and storing format in the PC journal
if ECR reads and successfully looks up the 13+2
bar-code
Printing format if ECR reads and successful-
ly looks up bar-code with other length than
15/18 or if a PLU has been read using the
PLU number that has length 15/18 and ECR
database contains the same EAN code with
given length (i. e. it is not considered an EAN
13+2/13+5 code)
Meaning
Communication protocol for Electronic scales on
PC port
(C
) button flags values will be printed. It is possible to print the value of the parti-
HECK
(E
) button.
AN
(R
) key. The display shows the number of programmed tax level and its rate.
EFUND
TAX RATE
1
(S
) key. Display will show label for programming the tax level name.
UBTOTAL
5.00%
(T
) key.
OTAL
0 – do not print and store anything,
1 – print and store only bar-code exten-
sion,
2 – print and store entire bar-code
0 – do not print anything,
1 – print entire 18-digit long code
programmed for given PLU
Valid values
0 – CAS Morcan, MARTES T,
1 – Euro scales, MARTES M,
2 – Macca K, 3 – Dibal,
4 - Mettler Toledo, 5 - Acom,
6 - CAS TP2, 7 - Motex R
(D
.
) button.
ISCOUNT
Advertisement
Table of Contents
Need help?
Do you have a question about the Euro-2100TE and is the answer not in the manual?