Tearing Paper; Printing A Configuration Test Page - Intermec PB 3 User Manual

Mobile printer

Hide thumbs Also See for PB 3:

Table of Contents

Tearing Paper

Note: Using the tear bar is the only way to tear the paper. Pulling up

and pulling sideways without using the tear bar can cause a paper jam.

The paper door acts as a tear bar. Pull one edge of the paper against

the tear bar, and then tear down and across against the tear bar to tear

the paper.

The tear bar has sharp edges. Be careful when tearing paper or

when handling the paper door.

Once the battery is charged and paper is loaded, you can print a

configuration test page. Use this information for reference when

installing the PB3 and to verify correct printer operation. If you

cannot print the test page, see

Note: If you are using the AC adapter/charger as a power source, the

printer will not print unless a battery is installed.

To print a test page

1 Make sure the printer is off before you begin.

2 Press and hold the Feed button.

3 Press the Power button once to turn on the printer. When the

printer starts printing the test page, release the Feed button.

4 To stop or cancel printing the test page, press either the Power or

Feed button.

"Troubleshooting" on page 18.

PB3 Mobile Printer User's Guide

Table of Contents

Pb2