Table of Contents
Advertisement
180
InfoPrint 3000 Operator's Guide
1. Open the rear center and rear right covers of the printer.
2. Remove the cap from the oil reservoir. Put the cap in a safe place.
3. Locate a bottle of fuser oil and a plastic spout. (Every new package should
contain a bottle of fuser oil and a plastic spout.)
4. Ensure that the spout is clean.
5. Remove the bottle lid and the inner seal.
6. Screw the spout onto the bottle of fuser oil.
7. Bend the spout and carefully place it into the oil reservoir opening.
Operator Tip
When you add fuser oil, be careful to pour slowly. A filter in the
reservoir restricts the flow of fuser oil.
8. Tip the fuser oil bottle to let the fuser oil drain into the oil reservoir.
Advertisement
Table of Contents
