Chapter 2. Operator's Overview; Operator Responsibilities; Mode - IBM INFO PRINT 3000 Operator's Manual

Chapter 2. Operator's Overview

Operator Responsibilities

Table 2 summarizes the responsibilities of the operator.
Table 2. Operator Responsibilities
What to Do:
Power on/off the printer and
enable/disable attachments
Clean all functional areas of the
printer
Define and load forms
Thread forms (duplex mode),
ensure proper form alignment,
and verify side 2 printing
Change mode from duplex to
dual simplex, or dual simplex
to duplex
Empty stacker
Check print quality and print
samples
Adjust the print position
Replenish and check supplies
© Copyright IBM Corp. 1998
Chapter Overview
This chapter provides an overview of the operator tasks and the general
operation of the printer.
When to Do It:
As necessary
v Once per day
v Before and after printing
adhesive labels
As necessary
When loading new forms, after
a power on or restart, and after
any machine-detected errors
As necessary
As necessary
v At the start of every shift
v Before and during any
important jobs
As necessary
As indicated by messages on
the Display Touch Screen of the
affected printer
Where to Find More Information:
"Controlling the System Power" on page 56
"Enabling and Disabling Attachments" on page 63
"Cleaning the Printer" on page 88
"Defining Forms" on page 247
"Loading Forms (Simplex or Dual Simplex
Mode)" on page 102
"Loading Forms (Duplex Mode)" on page 115
"Thread/Align Forms" on page 152. Also see
"Verification Marks" on page 224.
Change the "Printer Mode" using "Switching
Printer Modes (Dual Simplex/Duplex)" on
page 172
"Unloading the Stacker" on page 169
"Checking Print Quality" on page 85
"Adjusting the Print Position" on page 68
"Adding Fuser Oil" on page 179
"Changing the Toner Cartridge" on page 182
"Checking the Toner Collector" on page 186
"Changing the Toner Collector" on page 188
"Changing the Developer Mix" on page 191
"Checking the Fine Filter" on page 200
"Changing the Fine Filter" on page 201
9